Product Features
Cabinet and General Features

• Enhanced grommets - secure & tight.
• Multi-position available from factory, or field convertible with accessory kit.
• Side return right- or left-hand capable on 12-30, 36 size models.
• All air handlers are basaloid packaged with bar coding and full description on label.
• Filter rack door with thumb screws for easy access and replacement.
• Fiberglass air filter comes with every air handler and filter racks accepts readily available size filters.
• Rigid taupe painted cabinets constructed of heavy gauge steel to prevent corrosion and are lined with high quality
• 5/8" foil faced insulation to prevent sweating.
• UL lab tested 2% or less cabinet air leakage for better efficiency.
• Approved for installation in manufactured housing and mobile homes.

Evaporator Coil Features

• Lanced fin design and internally enhanced copper tubing.
• Suitable for use with R-22 and R410A.
• Dual 3/4" FPT left and right condensate drain connections.
• Drain pans are molded of corrosion proof high temperature (450a°F) engineering polymer.
• Coils are air pressure tested at 500 PSI, pressure tested with helium, sealed and then charged with dry air.
• Piston, A/C TXV, or HP TXV available factory installed. Screw-on TXVs also available for field installation.

Hot Water Heat Features

• Suitable for potable water systems.
• Hot water heat kits available both factory and field installed.
• Easy to replace hot water coil. Remove one screw and slide out.
• Optional factory installed circulating pump fully encased in cabinet.
• Optional factory installed 130 degree F Aquastat delays water circulation until hot.
• Purge valve on hot water coil allows for manual release of any air trapped in coil during installation or servicing.
• Water connections 7/8" ODF (for 3/4" water pipe) on 12 - 30, & 36 size models and
• 1 1/8" ODF (for 1" water pipe) on 31, & 37 - 60 size models.

Variable-Speed High Efficiency ECM Motor Features

• Variable-speed control board includes dry contacts for thermostat connections.
• Constant air circulation feature runs airflow at 50% of cooling CFM, improves IAQ and eliminates stratification.
• Control board LED Lights display operation mode and when dehumidification is activated.
• Dehumidification - cutting dehumidification resistor on variable-speed control board reduces cooling airflow by 10%.
• Choose your own cooling/heating airflow settings, by selecting taps A-D on the variable-speed control board.
• Fine tune your airflow setting by selecting (+) tap to increase airflow by 10% and (-) tap to decrease airflow by 12%.
• Soft start feature runs airflow at 82% of cooling CFM for first 7.5 minutes of operation.
• Time delay- 1 minute blower off delay at the end of a call for cooling.

Electrical Features

• Blower door safety switch on all models.
• Dynamically balanced high efficiency three-speed motors for project flexibility.
• Easy to adjust blower speeds for fine tuning customer comfort.
• Electrical connections can be made on top or both sides of cabinet.
• Electric heat kits available factory installed for 2.5 & 5 Kw. Higher Kw heat kits available for field installation.
• Factory installed fan time delay postpones blower shutoff 30 seconds in heating mode and 45 seconds in cooling mode.